Grease Fill Pump GTP

• SKF electric grease filling pump GTP
• For pumping lubricants from separate grease containers
• Design: gear ring pump
• Temperature range: -10 to +50 °C
• Installation position: vertical
• Pump drive: electric motor with starting capacitor and planetary gear
• Connection voltage: 230 V AC / 50 Hz
• Motor power: 0.75 kW
• Discharge volume: 2500 cm³/min
• Nominal discharge pressure: max. 100 bar
• Protection class: IP54
• Insulation class: F
• Current consumption: 9 A
• Electrical connection: Schuko plug, 3 m cable, motor protection by device circuit breaker
• Lubricant: flow pressure max. 700 mba, greases of NLGI class 1, 2

Electric grease filling pump GTP

For pumping lubricants from separate grease containers. The electric grease filling pump GTP (Grease Transfer Pump) is a gear ring pump for grease containers of 25 kg/30 l. Pump frames for grease container sizes from 50 to 200 kg are available on request.

After switching on the main switch on the terminal box of the pump, it is ready for use. The functional status is displayed via 2 LEDs. Green indicates the power supply and yellow indicates that the pump is ready for use. The pump pumps as long as the button on the cable remote control is held down.

The grease is sucked into the container under the follower plate and pumped using a gear ring pump. When the follower plate reaches the bottom of the container, an empty signal switch (optional) is activated, which switches the pump off automatically. Opening the vent makes it easier to replace the empty grease container.

Hose lines in different lengths with the corresponding couplings are available for connection to the pump container to be filled.

Properties

• Purely electric drive
• For grease container sizes from 25 to 200 kg
• For pressures up to 100 bar
• Filling hose with quick coupling or connection with M30×2 thread
• High delivery volume of up to 2500 cm³/min

Advantages

• High performance even where there is no air connection, only a power connection
• Fast filling even at low temperatures
• Time and energy-saving alternative to manual filling
• Easy to handle in mobile use

Fields of application

• Filling of central lubrication units, e.g. in the areas of Wind energy, Vehicles, General mechanical and plant engineering
• Mobile use for service teams